I was contacted by co-author Ed Hawkins and was able to provide specific information for the AC&Y cars which was incorporated into the article. Several models are offered in HO scale. The Society also produced decals in N-scale, HO, S and O-scale for the correct AC&Y lettering schemes and variations. It is possible they are still available? Also, the Cyclopedia does include many excellent photos of the AC&Y cars and for other owners and lessors. As information. REL
- 1947 Build with National B-1 RB trucks
- ACY 518 - Copy.jpg (331.52 KiB) Viewed 2217 times
- 1942 Build ACF C/H with plain bearing trucks
- ACY 502 - Copy.jpg (337.63 KiB) Viewed 2217 times
Question : Where did / who made the National B - Timken roller bearing trucks on the one car picture you attached ? I have been unable to find these.
The society has indeed made decals for the original paint scheme that appeared on these cars - Akron Canton & Youngstown spelled out across the letter board.
The cars carried several other paint schemes during their long ACY careers. I have decals available for the circle herald cars as well as the "lemon" herald cars.
The number fonts and car weigh data fonts changed as these cars were re-painted , and I have these changes included as well. Combining the lettering from the societies set and mine allow any paint scheme to be done - EXCEPT the reverse car - the black #535.
As you mention, National B-1 roller bearing trucks (Timken bearings) were incorporated in the second series (1947 build by American Car & Foundry) of twenty-five AC&Y two-bay 70-ton covered hoppers (AC&Y 515-539). There are currently no off-the-shelf trucks in HO scale that can be used for these cars. I modeled the RB trucks starting with National B-1 plain bearing trucks. I believe this was or is offered by Walthers / Proto 2000. I'm certain they are still available. I carefully removed the plain bearing end from the journal by cutting and filing to create a new flat surface. There are several sources of low-cost (sacrificial) trucks with roller bearings and also brass castings by Custom Finising / Bob Rzaza for the specific Timken end caps, part #190. See truck parts listed at http://www.customfinishingmodels.com/DetailParts.pdf. The sacrificial trucks require carefully removing the roller bearing end cap, then gluing it with ACC to the PK2 National B-1 truck. The brass castings require a little cleanup, but the process and results are the same.
While I did not modify the roof hatches as outlined in the Cyclopedia article, I did add the eight "toe holds". These are short angles welded to the top side adjacent the roof hatches. They're a safety feature in providing some leverage when opening the longitudinal hatches (which folded toward the center of the cars). Also, note a small plate in yellow on the second series provide safety warnings to ensure hand brakes were set on the roller bearing cars.
Glad to know there are alternate scheme decals for these cars. Not mentioned in the Cyclopedia issue is the AC&Y covered (along with cars from other roads including NKP) were assigned to PPG in Barberton for soda ash service. REL
- AC&Y 535 with National B-1 RB Trucks
- ACY 535 - Copy.jpg (302.24 KiB) Viewed 2142 times
Who is online
Users browsing this forum: No registered users and 1 guest